How to operate sheet metal cutting hydraulic shearing machine

QC12Y-6X2500mm swing beam shearing machine operation instruction

Step 1:

Loosen the bolts on the top fuel tank, open the lid of the fuel tank, and fill it with 46# hydraulic oil. Fix the tank lid after full filling the hydraulic oil. 

Step 2:

Connect the electric power input three-phase wires to the electric cabinet terminals (L1 L2 L3). Push the switch upwards to turn on the power.

Step 3:

Turn on the key switch, Screw to release the emergency stop buttons (the first emergency stop button is on the E21 system panel, and the second button is on the foot pedal), start the oil pump, press the green RUN button, then step on the pedal, and release it by foot.

Step 4:

Adjust the blade gap by the hand-wheel. There is a point hole on the wheel with a ruler. The point original position directing to the ruler is 0. You can cut different thickness sheet metals. For example, to cut a 1mm thickness of sheet metal plate, you can rotate the point position to 0.1, the ratio is 1:10. To cut a 2mm thickness of sheet metal plate, you can set the point position to 0.2. And so on.

Step 5:

Set the cutting width. Press the DOWN arrow on the E21 system control panel, move the cursor to the “XP” position, enter a target size such as "280", press the green arrow and the green run key, then we can see that the back gauge is moving backwards to 280. And the target value on the E21 system has become to 280, then step on the foot switch

Step 6:

Set the actual X axis position. Press the red button to modify the current value, modify the position of the X axis, press the "P" key twice, enter the password "1212", and then press the green arrow to confirm, and then you can see the X axis reaching 280. Measure the actual X axis distance. Insert the measured distance here. If the measurement is 300 at this time, insert 300, press the green arrow to confirm, and then press the "P" arrow 2 times to return. At this time, we see that the "X" value has become 300.