What should be paid attention to before using progressive press?

The progressive press is an essential tool for any reloader, as it allows for quick and efficient reloading of ammunition. With a progressive press, you can easily produce large quantities of ammunition in a short amount of time, which is ideal for those who shoot regularly or for those who need to have a large supply on hand. If you are considering taking up reloading, be sure to add a progressive press to your list of must-have equipment.

• How does the progressive press work?

• What is the function of progressive press?

• What should be paid attention to before using progressive press?

How does the progressive press work?

A progressive press is a type of printing press that can automatically print on both sides of a sheet of paper. This is done by using two sets of printing plates, one for each side of the paper. The plates are mounted on cylinders that rotate in opposite directions.

The advantage of a progressive press is that it can print large quantities of material very quickly. The disadvantage is that it can be more expensive to set up and operate than a traditional printing press.

What is the function of progressive press?

A progressive press is a reloading press (a staple tool for assembling and loading your own ammo at home) that allows you to perform multiple reloading operations per stroke of the machine's handle.

For example, progressive reloading presses have multiple "stations" where old brass casings are deprimed and resized, new primers installed, powder charged, bullets installed, and in some case, also being crimped in place. All these operations occur simultaneously on a progressive press.

A progressive press is in contrast to a single-stage heavy-duty press, in which only one action is performed each time the handle is pulled.

What should be paid attention to before using progressive press?

1. Preparation:

First connect the main power supply of the workshop as required; start the (cooling water) circulation system; air compressor. And check whether its operation and pressure are normal. Are the pipes and joints leaking? To ensure the normal supply of water, electricity and gas.

2. Check that the setting values of each auxiliary machine meet the setting requirements.

Start the feeding machine and dryer according to the requirements, pay special attention to the mold with a hot runner, first check whether the wiring is correct and firm. And turn on the cooling water or mold temperature controller of the mold first to ensure that the mold reaches normal temperature before heating the hot runner. (Check the heating conditions of the mold temperature controller and hot runner at any time.) Ensure that the mold will not be partially overheated, which will cause the seal inside the mold to fail and the moving parts to wear.

Yingxin World Machinery was established in Shanghai in 2009 authorized by World Group to act as an exporting center for all World brand machines including the power press machines, hydraulic shearing machines, hydraulic press brakes and automatic accessories.